全文获取类型
收费全文 | 6891篇 |
免费 | 678篇 |
国内免费 | 266篇 |
专业分类
电工技术 | 154篇 |
综合类 | 382篇 |
化学工业 | 2177篇 |
金属工艺 | 328篇 |
机械仪表 | 140篇 |
建筑科学 | 578篇 |
矿业工程 | 1164篇 |
能源动力 | 210篇 |
轻工业 | 245篇 |
水利工程 | 141篇 |
石油天然气 | 1044篇 |
武器工业 | 18篇 |
无线电 | 147篇 |
一般工业技术 | 311篇 |
冶金工业 | 723篇 |
原子能技术 | 21篇 |
自动化技术 | 52篇 |
出版年
2024年 | 13篇 |
2023年 | 75篇 |
2022年 | 158篇 |
2021年 | 188篇 |
2020年 | 218篇 |
2019年 | 174篇 |
2018年 | 157篇 |
2017年 | 205篇 |
2016年 | 307篇 |
2015年 | 251篇 |
2014年 | 397篇 |
2013年 | 385篇 |
2012年 | 503篇 |
2011年 | 511篇 |
2010年 | 382篇 |
2009年 | 388篇 |
2008年 | 334篇 |
2007年 | 412篇 |
2006年 | 422篇 |
2005年 | 365篇 |
2004年 | 313篇 |
2003年 | 285篇 |
2002年 | 260篇 |
2001年 | 235篇 |
2000年 | 178篇 |
1999年 | 150篇 |
1998年 | 121篇 |
1997年 | 101篇 |
1996年 | 83篇 |
1995年 | 65篇 |
1994年 | 33篇 |
1993年 | 36篇 |
1992年 | 25篇 |
1991年 | 23篇 |
1990年 | 16篇 |
1989年 | 13篇 |
1988年 | 9篇 |
1987年 | 17篇 |
1986年 | 5篇 |
1985年 | 5篇 |
1984年 | 3篇 |
1983年 | 5篇 |
1982年 | 2篇 |
1980年 | 2篇 |
1979年 | 2篇 |
1977年 | 1篇 |
1976年 | 1篇 |
1951年 | 1篇 |
排序方式: 共有7835条查询结果,搜索用时 15 毫秒
1.
为提高准东露天煤的成浆性能,利用宽沟煤、乌东煤、北山煤、黑山煤、红沙泉煤5种煤与准东露天煤进行了混合制浆实验,考察了各单种煤的成浆性能以及单种煤最高成浆浓度条件下混合制浆的煤浆性能。单一准东露天煤浆的成浆性研究表明:准东露天煤单独制浆时,在添加剂添加率3‰下,煤浆最高质量分数为47%,黏度650 mPa·s,但煤浆流动性和稳定性一般。与不同种煤混合制浆研究表明:准东露天煤与宽沟煤、黑山煤容易混合成浆,煤浆的浓度、流动性、稳定性均有明显提高;在准东露天煤与宽沟煤、黑山煤质量比5∶5时,煤浆质量分数可达57%,可满足水煤浆气化炉生产对煤浆的要求。 相似文献
2.
3.
Chia En Liu Wen Chieh Lan Hao Ting Yu Han Lin Yang I. Tseng Liu Hsiao Ping Hsu Chung Wen Lan 《International Journal of Applied Ceramic Technology》2020,17(1):146-152
Silicon kerf loss during wafer slicing and the broken quartz crucibles after silicon casting are two major solid wastes from photovoltaic (PV) industry. Especially, the recycle of kerf-loss silicon has become an urgent issue because near 100 000 t of solid wastes are generated every year. One of the most meaningful recycle routes of the kerf-loss silicon is to make silicon nitride crucibles to replace the quartz crucibles. In this study, we demonstrated how this is feasible through acid leaching refining, slip casting, and nitridation. The reaction-bonded silicon nitride (RBSN) crucibles after oxidation were found pure enough for silicon ingot growth. More importantly, they could be reused after ingot growth. With the present examples, the potential of using the kerf-loss silicon for fine ceramics is prominent. 相似文献
4.
5.
水煤浆管道输送摩阻损失研究 总被引:1,自引:1,他引:0
以十二醇醚为分散剂,进行了水煤浆管道输送实验研究,分析了分散剂浓度和煤浆浓度变化对煤浆摩阻损失的影响。煤浆管道输送数据分析及理论计算结果表明: 分散剂浓度越大,煤浆摩阻损失值越小; 水煤浆浓度越大,摩阻损失值越大。实验数据拟合结果表明有效黏度与平均切变率成线性关系,从理论上给出了煤浆摩阻损失的计算公式,计算值与实测值偏差不大于18%。 相似文献
6.
采用无氰电镀工艺在TC4合金表面制备了Cu/石墨复合镀层,研究了镀层的组织结构和摩擦磨损行为。结果表明,采用无氰电镀方法能够在TC4合金表面制备出组织致密且与基体结合紧密的Cu/石墨复合镀层,但增加镀层中石墨的含量会降低镀层与基体合金的结合强度,并导致硬度小幅下降。摩擦磨损实验结果表明,Cu/石墨复合镀层具有优良的摩擦磨损防护性能,归因于石墨有效降低了镀层的摩擦系数和磨损率;对镀层磨损形貌、磨损产物和摩擦系数的综合分析结果表明,纯铜镀层的摩擦磨损机制主要为犁削磨损、黏着磨损和剥层磨损,Cu/石墨复合镀层的磨损机制为轻微的削层磨损和疲劳磨损。 相似文献
7.
《中国有色金属学会会刊》2020,30(2):318-332
The hot cracking tendency of 7075 semi-solid alloy under different conditions was studied by critical diameter method. The experiment and simulation results show that the dendrite arms of the rod grow from the edge to the center. The smaller the diameter of the rod is, the more obvious the directional growth of dendrite is, and the greater the tendency of hot cracking is. Compared with ordinary melt, for semi-solid slurry, increasing mould temperature or decreasing pouring temperature can significantly decrease hot cracking tendency of 7075 alloy, decreasing hot cracking grade from 256 to 100 mm2. Furthermore, based on the RDG criterion, the effects of solidification conditions on the hot cracking tendency were discussed combined with simulation. At the same time, the application and development of RDG criterion were also researched. 相似文献
8.
充填体作为人工矿柱,为矿房回采创造了条件,但经常受到爆破等冲击荷载作用。充填体的动态力学特性直接关系到充填采矿法的安全高效实施。通过单轴压缩试验和分离式霍布金森压杆(Split Hobkinson Pressure Bar,SHPB)试验技术,进行了不同充填配比参数的超细全尾砂充填体压缩试验,得到其静载和动载下的应力-应变曲线和能量变化曲线,并分析了其破坏模式。研究表明:充填体质量浓度越高,灰砂比越大,峰值应力和峰值应变随之增大,呈现正相关性,其中灰砂比和质量浓度对应力的影响相对一致,但应变受质量浓度影响更大;当冲击荷载由0.3 MPa增大至0.6 MPa时,充填体的破坏形式由保持完整形态变为产生裂纹,直至被压碎,转变为完全失稳破坏状态;充填体能量吸收随着冲击荷载的增加而逐渐递增,但质量浓度和灰砂比增大时,充填体比能量和能量吸收率反而下降,其中灰砂比是影响充填体吸能效率的主要因素,质量浓度次之。 相似文献
9.
10.